![]() When the product is still wet it can be removed with mineral turpentine, otherwise if the product is dry it can be removed by sanding or scraping.The product will fully cure up to 7 days. In most situations strong bonds can be achieved after 24 hours and will continue to strengthen over a 2-3 day period. The time it takes to form a strong bond depends on the nature and conditions of the application.Allow surfaces to dry 2-5 minutes before firmly joining. For faster grab, apply to one surface only, press together and pull apart. Allow the adhesive to set (at least 24 hours) before removing any temporary fasteners or clamping.The product is repositionable for up to 20 minutes after fitting. Fix the surfaces with sufficient nails, screws or clamping to hold load and achieve contact over the total bond area.On broad flat surfaces apply beads every 40cm. Apply a bead of product along the length of the joist, stud or batten.We also recommend sanding the surface back with a good quality sanding block, as the construction adhesive will adhere more readily to a scratched up surface.Highly oily timber types may need to be wiped with solvent prior to application to remove surface oils. On wet timber pooled water should be wiped off. If the surface is non-porous eg glass or metal, firstly clean the surface with Mineral Turpentine and then again with Methylated Spirits, and allow to dry. If porous surfaces are greasy or dirty, we would recommend cleaning the surface and allow to dry. Ensure the surfaces to be bonded are clean, dry and free from dust, grease, oil and loose powdery materials.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |